![]() ![]() It sounds impossible and inconceivable, but that's what happened. No, I was not switched to the new admin account I was still in the old one where I had had all the problems. When I went to reinstall 3 PFS plugins using the PFS Installer (Batch Install), my old, problem admin account immediately reverted to the status of a completely new admin account. When I removed all those plugins, the start time went from 7 mins down to 43 seconds. The problem apparently had something to do, at least partially, with plugins purchased from Pixel Film Studios. Go and show some love over on his site-creation and sites. Motion was taking 7 minutes to start, but now only 6 seconds, following the advice of fox_m. Starting Motion will now open a blank project immediately, skip the Project Browser, and avoid the head-numbing delay when a lot of plugins are installed in FCP. ![]() Set up a Blank Motion Project with your desired default Preset setting. Under For New Documents, select Use Project. Per fox_m, in Motion Preferences select the Project tab/page. I confirmed that by uninstalling most of my plugins and adding them back the load time went down to 11 seconds and back to several minutes as I reinstalled various plugins. If you have Plugin Acquisition Syndrome as bad as I do, then Motion has a ton of plugins to go thru and list in the Plugin Browser, and that literally can take minutes - in my case, a full 7 minutes. In short, when Motion is set in Preferences to open to the Project Browser, Motion apparently goes thru all available projects, including all (or many) plugins installed for FCP. Mr fox_m gave me the solution to this problem. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |